倍加福KCD2-UT2-EX1安全栅

倍加福KCD2-UT2-EX1安全栅特征
•单通道
•24v直流电源(电源线)
•热电偶、RTD、电位器或电压输入
•电流输出0/4 mA…20mA
•接收器或源模式
•可由PACTware配置
•线路故障(LFD)和传感器烧毁检测

应用
这种隔离屏障用于内在安全应用。该设备转换RTD输入信号或热电偶输入危险区域信号为0/4毫安。20mA信号在安全区域。可移动终端块KC-CJC-**可用当热电偶内部冷结补偿时想要的。led acc表示故障。到纳穆尔奈44号去用户配置的故障指示输出。如果使用带有动力导轨的装置，则产生集体误差消息传递功能可用。使用PACTware可以很容易地配置该设备配置软件。

技术参数
General specifications
Signal type Analog input
Supply
Connection terminals 9+, 10- or power feed module/Power Rail
Rated voltage Ur 19 ... 30 V DC
Ripple within the supply tolerance
Power dissipation/power consumption ≤ 0.98 W / 0.98 W
Interface
Programming interface programming socket
Input
Connection side field side
Connection terminals 1, 2, 3, 4
RTD type Pt10, Pt50, Pt100, Pt500, Pt1000 (EN 60751: 1995)
type Pt10GOST, Pt50GOST, Pt100GOST, Pt500GOST, Pt1000GOST (6651-94)
type Cu10, Cu50, Cu100 (P50353-92)
type Ni100 (DIN 43760)
Measuring current approx. 200 μA with RTD
Types of measuring 2-, 3-, 4-wire connection
Lead resistance ≤ 50 Ω per line
Measurement loop monitoring sensor breakage, sensor short-circuit
Thermocouples type B, E, J, K, N, R, S, T (IEC 584-1: 1995)
type L (DIN 43710: 1985)
type TXK, TXKH, TXA (P8.585-2001)
Cold junction compensation external and internal
Measurement loop monitoring sensor breakage
Potentiometer 0 ... 20 kΩ (2-wire connection), 0.8 ... 20 kΩ (3-wire connection)
Voltage selectable within the range -100 ... 100 mV
Input resistance ≥ 1 MΩ (-100 ... 100 mV)
Output
Connection side control side
Connection terminal 5: source (-), terminal 6: source (+), terminal 7: sink(-), terminal 8: sink (+)
Output Analog current output
Current range 0 ... 20 mA or 4 ... 20 mA
Fault ** downscale 0 or 2 mA, upscale 21.5 mA (acc. NAMUR NE43)
Source load 0 ... 550 Ω
open-circuit voltage ≤ 18 V
Sink Voltage across terminals 5 ... 30 V. If the current is supplied from a source > 16.5 V,
series resistance of ≥ (V - 16.5)/0.0215 Ω is needed, where V is the source voltage.
The maximum value of the resistance is (V - 5)/0.0215 Ω.